|
Tractor Talk Discussion Board |
Re: TRUCK /DEALER PROBLEMS ADVICE APPRECIATED
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CLW on December 07, 2006 at 07:59:34 from (68.89.124.5):
In Reply to: TRUCK /DEALER PROBLEMS ADVICE APPRECIATED posted by THEJDMAN01 on December 06, 2006 at 16:33:48:
I think you should give the dealer and the company that did the undercoating every chance to make it right before going to the next step. I would hold off on a lawyer until all else fails.
I have read where anything but factory undercoating CAN plug drain holes and are no longer advised but that is up to each of us to decide for ourselves.
I agree with VADAVE about the slip in bedliner. The last GM I bought new was a 1994 and in the owners manual it said you should only use the one installed by the dealer. Then the next line says it "may void your warranty" if you do use it.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
