Tractor Talk Discussion Board |
Re: 160* Thermostat, why?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom in TN on December 13, 2006 at 20:45:04 from (4.152.96.218):
In Reply to: 160* Thermostat, why? posted by Aaron Ford on December 13, 2006 at 17:31:55:
Aaron, I'm sure that most guys will disagree with this, but it's what I do nonetheless. I don't use a thermostat at all in my 1973 Ford 2000 gas tractor. When I started working on cars back in the 1950's in Ohio, no one used a thermostat in the summer. Thermostats were only installed in the Fall so that the heaters would work more efficiently. Everyone removed the thermostats in the Spring and ran until Fall without one. I've heard all of the arguments about condensation in the engine, oil temperature, incomplete combustion etc. However, in my experience, I don't see that any of those things happen. The temperature inside the engine is in hundreds of degrees. Having the water going through the cooling passages a few degrees hotter or cooler doesn't make enough difference to talk about. The oil in my engine gets very hot without a thermostat - just touch the dipstick some time. I don't have black smoke coming out of the exhaust, etc. I never have to worry about air trapped in the system, and I've never had a thermostat failure in my tractor (since it doesn't have one). So, I've "exposed my soft tissue" on this matter, but I'm probably not going to change my mind at this point anyway. Good luck, Tom in TN
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|