Tractor Talk Discussion Board |
Re: Amsoil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by fixerupper on January 09, 2007 at 20:49:36 from (206.72.37.202):
In Reply to: Amsoil posted by Youngfarmhand on January 09, 2007 at 18:34:11:
Well, I have one near side-by-side comparison, if I want to call it that and it's by no way scientific, but my brother-in-law bought a new 1086 in 1978 and I bought one a couple of months later. Both of them had about the same useage on livestock farms grinding feed, pulling wagons and doing a lot of field work. Both of us take very good care of our machines. He used synthetic oil and it was Amsoil for awhile but I don't know if he used it for long or not. I do know it was synthetic for most of the life of the tractor. I have always used mineral oil purchased from the dealer I bought the tractor from. We both did a complete overhaul at 5000 hours and then again at around 10000 hours. At the second overhaul he had to have the crank ground, the cam was worn past specs, and the oil pump, which was new at 5000 HRS had to be replaced. The crankshaft on my 1086 showed no wear and the camshaft had about 35% left so I re-used it. The oil pump was the origional one but it did need to be replaced. My 1086 now has a little over 14000 hours and I don't have to add oil between changes and the oil pressure runs about 40 at a hot idle. Was the oil that I used better stuff? I don't know. It could have just been the luck of the draw. Jim
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|