Tractor Talk Discussion Board |
Re: Amsoil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by kyhayman on January 10, 2007 at 09:53:46 from (64.12.116.74):
In Reply to: Amsoil posted by Youngfarmhand on January 09, 2007 at 18:34:11:
Id say its ok in a car, maybe in a pickup or highway truck. Personnally, I dont see the economics of it for me. I get the oil changed every 5000-7000 miles give or take in my car at the local 'fast change', they top off the fluids. Figure when I get the car (I normally buy a former rental car) its got 30,000 on it. When Im done with it at somewhere aroung 180,000-280,000 I'll usually get $500-$700 for it 6-8 years later. Figure I got my money's worth. Never had to put an engine in a car yet. Tractors and off road stuff, no way would I use it. Running in those kinds of conditions, the oil needs to come out. Too much microscopic grit in there no matter what kind of air and oil filters you use. I've never rebuilt an off road engine that ran on any of the 'extended' life synthetics that ran long oil changes which didnt have to have a crank, and usually a cam. Alomst always worn beyond where they can be ground. Regular mineral oil, if its changed right, I usually get the cranks polished 10 thousandths and theyre good to go. Bottom line for me, I cant see it except maybe in a semi or other high mileage on road vehicle. Cars are cheap, relatively, and disposable. If you change the oil with any kind of rated oil the engine should last as long as the car does. Off road, no way. If its an engine I plan on rebuilding every so often, I sure dont want to be leaving oil in it long.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|