Tractor Talk Discussion Board |
Re: 7520 john deere ,heavy smoke after it gets hot
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chrisfromsolitude on January 14, 2007 at 14:13:00 from (63.240.135.30):
In Reply to: 7520 john deere ,heavy smoke after it gets hot posted by FRANCIS PAWELEK on January 14, 2007 at 13:21:42:
Did he do a complete overhaul or just part of it? Also did a local deere dealer do it or an individual? Just wondering if he changed or checked the injectors while they were out. Also to breakin your new rebuild you should run it on a dyno about 15 min @ 25% power, 15 min @ 50% power then about half an hour at rated. Some people run them longer and some shorter but that is a good way to do it. This is usually how I break in a new engine. Check for blowby while on the dyno and be sure to check your coolant level when you get to cooled off. You could have oil in things but if the rebuilder did a good job he should have cleaned everything up before he put it back together and most of us run it on a dyno and break it in for you. Also make sure all of your air connections are tight and sealed up good. If it failed a turbo on the way home I would think that it had dirt somewhere that should have been cleaned up. The turbo should have also been checked when it was removed. If it was that close to going bad they most likely should have seen some signs of it. I'd check this stuff out and see where that gets you. Not blaming the rebuilder for faulty work, just looking at any possible angle. Hope this helps and good luck. Let us know what you find out.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|