|
Tractor Talk Discussion Board |
new barn almost finished-photo
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim, Ohio on January 15, 2007 at 12:03:32 from (71.29.223.3):
Hey guys, Here is our 30 x 56' barn. Thought I would share a photo of it. I started planning this last September asking all of you questions about bracing. I built this barn on concrete pilings. Each pole had a concrete piling to stand on at grade. The concrete was poured to the frost line after drilling 18" diameter holes. A post anchor was fastened to the top of the concrete with a 4.5" lag bolt. Each pole was fasted to an anchor, then stood up with bracing. We used a laser to give pole dimensions so we could cut them before standing them up. Everything was right on. I didn't like walking on the roof much. That 4/12 pitch is a bit steep. Now the only problem is keeping the floor dry. Just had gutters put on it, but considering a shallow french drain all the way around leaving gravel to grade. Anyone ever done this. I don't care if the grass grows up to the sides. Anyway, thanks for the input by many of you
last fall. Tim, Ohio
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
