Tractor Talk Discussion Board |
Re: 4020 update...........for what it's worth
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Robert Searcy on January 18, 2007 at 10:51:06 from (70.12.187.50):
In Reply to: 4020 update...........for what it's worth posted by Raleigh boulware on January 17, 2007 at 14:20:50:
I have been in the same dilema as yourself, trying to find a newer tractor than what I had. I have been looking at the 3020 Power Shift, D19 Allis, Farmall 656, etc.........not quite as large of tractor as you but still looking for something something more modern. I found a 560 Diesel with a schwartz wide front, T/A replaced, new clutch, new brakes, 656 square fenders, only thing I could find wrong with it was tires. they would make good ones for pulling but not for daily use pretty far gone. It has an oring leaking under the seat so i might have to replace a couple of those. It doesnt have nice shifting trannie like the PS Deere but I just couldnt spend the extra 4K to 8K for that rught now, so I went with the Farmall. Incidently this tractor was a diesel and shows 5K hours, hour meter was working and tractor seemed to be in that range by the looks. ITs very clean, great sheet metal, external batteries, all glow plugs good, runs good. You will know a good tractor when you find it. You can usually tell by the care and condition and history from a private party. I bought it from a retired farmer. My suggestion would be patience, look at lots of them and dont limit yourself to one particular tractor unless you JUST HAVE TO HAVE A 4020. robert
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|