Tractor Talk Discussion Board |
Re: Which way do you guys do it?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on February 05, 2007 at 07:57:08 from (142.177.6.21):
In Reply to: Which way do you guys do it? posted by IaGary on February 05, 2007 at 04:02:54:
If I was doing that again, then I'd break them down, sandblast the wheels, prime them, and then coat with an epoxy paint. I like the epoxy because it stands up to CaCl and manure, and most of these wheels see lots of manure... The epoxy is hard enough that it stands up to tire bars without marking. Only downside is that you may need to work on the right colors. My Fords have white wheels, so that's fairly easy. It's rather expensive too, but it is a good solid coating. Know what you mean about installing wet too. I'd blasted, repaired and painted some wheels several years ago, and they got their last coat of enamel from a rattle can in the lot at the tire shop while the first was being mounted..... Twas a bit tacky..... Good luck. PS. The tractor is looking good. Rod
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|