Tractor Talk Discussion Board |
Re: What kind and what size winch?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ken Macfarlane on February 13, 2007 at 05:56:05 from (156.34.142.102):
In Reply to: Re: What kind and what size winch? posted by IH2444 on February 12, 2007 at 20:07:37:
What are you pulling too? A tractor and mower bogged to the frame needs something twice as heavy usually to winch too. A yank strap will usually get you out if you have something that weighs the same to yank you. The trees on the edge of field might look close but 200 ft of 1/2" cable is not common and a 20,000 LB pull will uproot some pretty big stuff. Last year a neighbour got her tractor stuck with a NH489 haybine on back. We couldn't budge it with two tractors, I had to drive mine in and get it stuck to use the loader to pick the haybine up and put planks under it. We then yanked my tractor out and then we barely were able to get her out with both machines.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|