Tractor Talk Discussion Board |
Re: 100 plus HP loader tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on March 22, 2007 at 04:02:33 from (216.208.58.191):
In Reply to: 100 plus HP loader tractor posted by fixer0070 on March 22, 2007 at 03:21:04:
Personally I'd go for the Deere with power shift. I had a 1066, it's strictly a brute force field transmission. On loader work, it's going to burn a whole lot more fuel than the Deere. Not going to be a smooth shifter for loader work either. I also had a Deere Forestry Skidder, same basic power train as 4020, same 8 speed power shift. You can hammer those those power shifts for years on shuttle work. I plowed a lot of snow, leveled and packed bunker silos with mine. You could push that thing all day, going from 3rd forward to 3 reverse, with nothing more than depressing throttle for the shift. Mine went 13,000 hours before that power shift required any repair or maintinence. This from a farmer that owned 16 Farmalls lifetime, and after all those Farmalls, I bought this Deere and I bought it for that power shift. I think had I stayed in farming, there would have been a whole lot more Deere around. Interesting, I also did disking 20'disk, with the Deere, it wouldn't haul the disk quite as fast as 1066, however I had the ocasional 10" rock. Those cowboys I employed didn't break disk blades at 4 mph with the Deere. The Deere also used a lot less fuel per hour and per acre. Bear in mind also, mine was bought new, and maintained by me all those years. So where my Farmalls. If it's loader or shuttle work of any kind I'd got Deere power shift. If I were buying a tractor for long days pulling heavy implements, no I wouldn't buy the power shift. Even today, I still make a note of what owners are using particular transmissions for.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|