Tractor Talk Discussion Board |
Re: 100 plus HP loader tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on March 22, 2007 at 19:35:47 from (64.228.11.14):
In Reply to: Re: 100 plus HP loader tractor posted by buickanddeere on March 22, 2007 at 18:12:32:
B&D: I don't think I'd too awfully concerned about Gary's setup as it applies to danger. I used to pull highway trailers loaded with grain behind my 1066, no loader mind you but with duals. I didn't go racing, but I had no trouble stopping 25 ton on level ground. Why just yesterday I was up your way, on the outskirts of Harriston, I caught up with a CaseIH 150+ hp 4x4 and duals, and behind him a fully functional Super B train. He had full tail lights, marker lights, signal lights and 4 way, plus he had fully operational air brakes. He was loaded full height, length and width with large square bales. He came to a hill, didn't slow him down a bit until he came too a stop sign. Once he had the right away, it was left turn from starting on the upgrade. He cleared the intersection as fast as any highway tractor would. If I met Gary on a down grade and he had enough 4 wheel wagons for 40 round bales, I'm certain I wouldn't be alarmed. These tractors have quite bit of ability to handle big loads. A 1066 or 86 with duals, 20' disk behind, at full throttle in high gear, on dry black top, has the ability to stop in 4'. I know it did cause some smart a$$ cop some grief, that decided to follow me on a dark night with high beam lights on. We had some harsh words, but he did rear end me. Didn't hurt the disk, but his cruiser didn't look quite the same. There was no point in me driving further as I couldn't see anything with those high beams behind me.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|