Tractor Talk Discussion Board |
Re: siezed engine, break towing in gear?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by oldcraneguy on April 09, 2007 at 07:31:38 from (65.8.178.197):
In Reply to: siezed engine, break towing in gear? posted by Donovan on April 08, 2007 at 15:00:26:
Blaster, Liquid wrench are both good but I like to top em off with ATF and give em a week or more if possible. And I wouldnt pull it at all. Stick it in the highest gear and rock it, if that doesnt budge it I pull the starter and get out the prybars or if you can get at the front of the crank with a big breaker bar that might do it. Also you can take an old sperk plug break out the insolator and weld/braze a grease fitting in it and put tons of pressure on the piston with out straining the rods/crank/flywheel, etc....Biggest thing is the longer you soak it the better, not just for getting it freed up but for having some rings left afterward...
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|