Tractor Talk Discussion Board |
Re: Castrol Tection 15W-40 oil in a JD 2 cylinder
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jon Hagen on April 14, 2007 at 11:40:55 from (75.104.56.247):
In Reply to: Re: Castrol Tection 15W-40 oil in a JD 2 cylinder posted by jdemaris on April 14, 2007 at 11:10:39:
JD, my oil information came from a JD shop forman a couple years ago,who said that with the new "low ash" multi viscosity oils that top ring sticking and buildup are no longer a problem, when I asked him if I still needed to use single weight oil in my 4020. He said the JD 15-40 multiweight was fine for any JD, no matter how old If you notice, most any newer multi weight series 3 diesel oils meet the Detroit diesel CD II spec which eliminated the need for a special low ash oil for them. I question your friends comment that multiweight synthetics do not have the same polymer viscosity improvers as multiweight mineral oil The additive package between synthetic and mineral oil is nearly identical, with only the thin base oils being different. A multi weight is a thin oil to give you good cold start lubrication,with the viscosity improving polimer additive that thickens as the oil heats up. A lot has changed in the 16 years since your 1991 D D oil buletin, within the last 5 years, almost all diesel oil uses low ash additives that eliminate the ring sticking problem, so no special oil is required. I checked that out very carefully, as I still run several 2 cycle Detroit diesel powered machines, and was very aware of their special oil requirements.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|