Re: MF 65 Starter Solenoid problems…
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MBU on July 06, 2007 at 12:51:40 from (68.176.136.151):
In Reply to: MF 65 Starter Solenoid problems… posted by MBU on July 05, 2007 at 20:29:13:
Jiles,
Thanks for the idea!
The backside of the lug is square (kind of like a plow bolt) so it won't turn when the battery cable is attached. You're right though... in a pinch your suggestion would work just fine! I ended up facing the front off and silver soldering a piece of copper on (.060" thickness). The total time to do it was about 8 minutes. Looking at it, I think it will last a long time.
Someone told me I can get replacement lugs for it for around $1.25 apiece. I think I'll see if that is the case and keep a couple on hand. This should completely eliminate any chance of me have this problem again and my heirs will have some copper lugs to throw away. :wink:
Thanks again...
Mike
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|