Tractor Talk Discussion Board |
Re: HELP!!- What rims will fit a 40's wards wagon
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul from MI on August 07, 2007 at 03:37:47 from (66.231.33.136):
In Reply to: HELP!!- What rims will fit a 40's wards wagon posted by Dave from MN on August 06, 2007 at 13:11:18:
Usually what goes bad is the rims rust out, sometimes near the valve stem hole. I have repaired other "oddball" wheels by cutting off the old rim and cutting the center out of another good wheel. If you are careful the weld won't be all that noticeable. Carefully mark both wheels before you start cutting and use some scrap to hold everything in line and level. It won't work for an Indy car but it's fine for a wagon or plow, etc. Paul
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|