Posted by Don-Wi on August 17, 2007 at 00:31:24 from (69.217.58.28):
I was cuttign some hay today and when i got off the tractor to open a gate, I noticed a bent nail sticking out of the right rear, right between the lugs. It was about 1/2 way in, but I wasn't gonna be up there for long so I decided to cut the 1 field beofr epulling it out to investigate.
I cut the 1 small field I had time for, unhooked the haybine in the field and drove the 1855 home, then parked w/ the nail on top. grabbed a pliers and pulled it out. The tire must have a heck of a thick carcass (Coop radial) because no fluid came out so far, the nail was dry, and didn't taste like salt or anything. It was in over 1" too....
It made me wonder what the heck we would do though if we did have to call the tire guy. We've been planning to put new rubber on it since we got it about 4 years ago, but we don't have the funds yet, and they pull great on dry soil. In the mud they don't have much traction because they only have about 30% tread left on them, but we've gotten by so far. Would be great for a puller on a dirt track...
When we do have them changed, we plan to put them on the dual rims, and then get rid of the other tires, which are old Firestone F&R's, that have no tread left on them (got the duals cheap enough so I don't feel bad)
But for now if the tire is still up and no fluid seeping out, they must be alright, by some stroke of luck. Hate to have a tire guy come out and put a new tube in, only to have to replace that tube when we finally do put new rubber on there... It's probably be about a $300 bill just for the service call and the tube. I ain't doing it myself, it just ain't worth it. Espescially with the fluid in there...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.