Posted by Allan In NE on October 24, 2007 at 12:56:12 from (148.78.243.24):
In Reply to: code read posted by noidea on October 24, 2007 at 11:47:37:
OBD II, but let an old guy give ya a tip.
Code readers/scanners will very seldom tell you what is wrong with the vehicle; that isn't it's purpose.
They only tell you what the computer has seen as "out of bounds" as far as the pre-set parameters go. It knows something is wrong, trips the light and sets the code, which your scanner then reads.
Therefore, it helps to have a good working knowledge of how any one particular outfit works.
What I'm saying is, don't just start throwing parts willy-nilly at the thing because you see a code set on your new $29 scanner.
Simple example: Both banks set O2 sensor "rich" codes. Doesn't mean that the sensors are bad; it only means that they are "seeing" a rich condition.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
