Posted by bryden on December 07, 2007 at 09:59:49 from (207.224.97.179):
i have jd 630 that i was putting rim & tire on . I worked on it one day and got half the wheel lugs on it. I would put one on at a time and then turn the wheel alittle in order to get the weight off the spot for the next lug, the next day I decided to try to start the tractor to run some extra antifreeze throught it that I just added, it wouldn't start felt like it was stuck, so I decided to finish the wheel lugs and then I would try to pull start it,however when I took it out of 5th gear because after turning the wheel alittle to put on the next lug I would put it in gear so it wouldn't turn while I put in the lug. it felt like it came out of gear fine but the wheel won't turn as if it is stuvk in gear. Any thoughts and if is stuck in geqr whats easiest way to get at it to unstick it, It was warm the day I tried this so I don't think it is from cold weathe ror moisture built up freezing,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
