Posted by Brokenwrench on December 07, 2007 at 10:18:52 from (75.100.181.199):
In Reply to: jd630 posted by bryden on December 07, 2007 at 09:59:49:
Make sure the brake isn`t stuck on. Sometimes those pedals don`t return.
I would be really careful about pull starting it if it feels like the engine is siezed.
I have a 730 gas, a couple of years ago it wouldn`t turn over. Had been fine the day before. I pulled the flywheel cover to see if I could move the flywheel by hand. I could just a little bit. I checked to make sure the starter was engaging and that I had a good charge on the battery. Dad came out and was bound and determined to pull start it, but something wasn`t right. He actually had the chain and another tractor hooked to it. I got the idea to pull the plugs and try to turn it over, BINGO. The low oil shut off on the carb had stuck open and gas had hydro locked the cylinder. So I spun her over with the plugs out for some time and blew air into the cylinder. I put the plugs in and she fired right up, after shooting flames about 10 ft in the air. I had the carb rebuilt, took care of the problem, but I bacame a believer in shutting the gas off at the tank anyway.
To make a short story long, I would`ve had big problems had we tried to pull start the old girl...
If the shift lever feels loose, like it will flop around into any gear without resistance, it could`ve popped out of the detent on the shift rail. Then you gotta line it back up with 5th gear and give it a good whack. You should feel it catch the fork and off you go. Good luck BW
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.