When I was burning a lot of wood, I built a small pole building for wood storage. It is about 12'x16' and is tall enough so I could swing a splitting maul without problems inside. I covered the building with galvanized tin, with an area of greenhouse fiberglass sheeting for natural light inside. I never put a door on the building and never had any problems with moisture, since the wood was pretty dry before I stacked it inside.
I generally stacked about 5 to 7 cords inside in rounds and split the wood as I used it. At first I didn't have electricity to the woodshed, and used a gas lantern to split at night a few times, but later I ran an underground cable to give me lights and power in the shed.
Before I built the woodshed, I would stack outside in a large pile under tarps and up off the ground on pallets. That worked OK, except that during those years we got lots of snow. Hauling in wood was a big job--first the boys and I had to remove the snow to be able to get under the tarps. I don't know if the boys or I appreciated the new woodshed more! It also helped keep the wood much dryer, since there was no problem with blowing snow.
My woodshed didn't cost me much. The pressure treated poles were the biggest expense, since I got the metal from a neighbor for almost nothing. It had sat in a pile at his place for at least 20 years without being used and he just wanted to be rid of it. I did get a building permit, but would not bother now with something that small. I also got by without putting concrete around the poles, since it was so small. My sons and I built it over a couple of weeks of spare time.
We don't burn much wood anymore, since the natural gas line went down our road. When we built the new house, I didn't put in a woodburner. But that may change if gas gets much more expensive. I have mostly used the woodshed for storage the last years, but it is there, ready and handy if I decide to start burning wood again. I would say that building the woodshed was absolutely worth it and one of the best little projects we ever did. Good luck with yours!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
