Posted by super99 on January 12, 2008 at 11:30:39 from (75.107.167.170):
A week ago, I used my 400 Farmall and let it run for about an hour since it hadn't run in a month or so. Tuesday nite I went out to start it, it turned over but wouldn't fire. It was drizzling, and I thought it was just damp and would start when it dried out. Tried Wednesday, clear out, same thing. I did some checking with my tester and there is power at the resistor before the coil and power going into the coil, but no power coming out of the coil. The general answers from here were to change the points and condensor. I put new points, condensor and rotor in this morning, and no fire at the points. I am guessing that the resistor before the coil is to change it from 12 volts to 6 volts? Is this right? The test light is brighter on the inlet side of the resistor than the output side going to the coil. What is the next thing to try to get it to fire? Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
