Tractor Talk Discussion Board |
Re: Why is a Zetor heavier than most tractors of same HP.
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by ltf in nc on December 27, 1999 at 19:10:04 from (206.228.214.219):
In Reply to: Why is a Zetor heavier than most tractors of same HP. posted by Malachi on December 27, 1999 at 14:33:43:
My own experience with castings that are outsourced in developing countries are as follows. The facilities and techniques are not much different than what existed in this country in the late 30's and 40's. However a major difference today is the source of the casting material. The source now being used is recycled cast of dubious origin. Engine blocks are segregated from the other items and this source of good material is recycled into new blocks. The balance of the scrap heap, (steam radiators, water pump housings, junk air compressors, rejected new castings, window weights, etc.) is destined for the cast housing components. This results in having to have overkill in the wall thicknesses of the components to overcome the weak spots resulting from such raw material. Herein lies the answer as to where the additional weight comes from. Frequently, when machining these parts the shops have tool breakage due to hardened material(stray ball from a bearing being left in a water passage of the block) getting into the scrap and the castings are also plagued with voids from slag. Most of these castings will be coated on the inside to minimize weeping or leaking through the castings. Knowing the above it is much easier to understand why many of these tractors stay wet with oil and what causes the unexplainable breaking in half or front ends collapsing. I have been to these places and seen this myself. This is not second hand information. I do not want one of these tractors.
Follow Ups:
Home
| Forums
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|