You've been haying 600 acres for 30 years? When your time comes, you'll automatically have your place in heaven, because you've already had your share of he11.
First thing that strikes me is that you should be the teacher here, rather than the pupil, based on your experience.
As far as patterns, most everyone seems to mow 4 or 5 rounds, then cut back and forth across the long axis of the field. I can see that being advantageous if you have a self propelled swather or a hydro-swing, where (after you have the outside rounds done, to get you some room to maneuver) you can just start at one side and go across; however, if you have a mower that is limited to the right side of your tractor, it seems like you would waste more time laying out "lands" (and running over grass to start them) than if you just kept going round and round til you're done.
Baling generally done clockwise (except the backswath), because it's easier to follow the windrow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
