135 Fan said: (quoted from post at 12:54:12 08/21/08) With the stabilizers up it wouldn't be too hard to lift the front of the backhoe. Lots of weight on the back and a lot of leverage. With them down, I can't see the front end lifting. The hydraulics wouldn't have that much power. Dave
Don't know what to tell you, Dave, except that the Ford 755 TLB backhoe hydraulics (and I suspect any construction BH) WILL lift the machine right off the ground or drag the machine in the dirt WITH the stabilizers down. Trying to use the backhoe to dig without the stabilizers is crazy. It will bounce the machine around as the weight shifts with boom movement. The only time I use the b/h w/o them down is if I'm using it like a mobile crane and moving stuff around, but then at a very slow pace.
In fact, the manual states the recommend method of repositioning is to push the BH backhoe bucket down into the ground to lift the machine, then swing it to pivot the machine to where you want it. Done it many times. (exceptionally useful when you bury it in the mud, LOL) When I bought it I didn't realize the difference between a true construction backhoe and a tractor mounted one. Now, my machine is pretty old and tired, pins not real tight, so I tend to be careful with how much I push it, but I can imagine that brand-new it was quite the machine. I've heard stories of Kubota backhoes bending cylinder rods. I can't imagine bending one of the 2" rods on the 755.
It was one of those lucky purchases where I wasn't smart enough to know that I was making a sound decision. :D
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.