Posted by Kent in KC on August 20, 2008 at 08:46:33 from (208.82.109.5):
I have a couple acres of woods along my house I'm trying to thin so the good trees can grow out better. I'm clearing mostly young locust, elm and ash 2"-6" in diameter. I'm using a small Poulan gas chainsaw.
Question 1: Does it make more sense to try to cut the stumps off at ground level (so my mower doesn't hit them) or a couple feet off the ground, then pull the stumps? I would use a JD 2020 to pull but I've never pulled stumps before so I need the short course on how you do that. (I know not to pull from the rear, pull from the front). How big a stump would you think I should be able to pull without too much trouble?
Question 2: How often should you need to sharpen a chain? (I know, when it gets dull) but how much would you expect to cut before it gets dull?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.