Posted by Lanse on August 27, 2008 at 13:49:01 from (64.12.117.74):
The front end on my C attatches with studs to the block. As it does this, it presses the timing cover gasket to the block.
In theory.
A few weeks back i poured in a quart of oil and it came right back out. Nice.
I dont know what it is, but i figured the front end wasnt pressing on the cover enough. A 4 mile each way trip to the hardware store produces the wrong size washers. LAst time i ever go there. They were $.50 each too.
Another trip to yuppie supply produces the right ones. So i get them on one stud. Then two. Then almost 3 and theres a snap. Now the nut wont come back off. Nothing moves on there. I would take a picture but in true Lanse Edwards style the camera doesnt work. Who puts fine thread studs on a tractor in the first place????
The wrench is 13" long. No cheater bars even. This tractor has been nothing but time, frustration, and money. How the hell do i fix this brillant move???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
