Posted by billimac bradley on September 03, 2008 at 13:38:11 from (70.254.170.160):
in the early 1960"s were farm tractor pto"s inside the tractor transmission with the pto shaft exposed through the transmission case to connect to an auxilliary implement, or were the pto"s separate units that could be attached to the tractor transmission through a removable hatch door? if the pto was an integral part of the farm tractor transmission,could the shaft of an electric motor (the motor mounted on the tractor and not attached to the transmission case)be connected to the pto shaft? the electric motor could then be used to input electrical power into the transmission to move the tractor in a forward motion. the clutch would be disengaged and the electric motor would rotate the pto and the transmission gears and drive shaft to rotate the tractor wheels. if this set-up can be done, would the OEM transmission warranty be violated and cancelled?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
