Posted by mark on December 31, 2008 at 13:23:43 from (172.131.18.180):
In Reply to: oil change intervals posted by buickanddeere on December 30, 2008 at 08:45:50:
I wish there was a way to certify or verify.....whatever the proper term might be...what I am about to say.
I am 51 years old. My 'new' tractor is 3 years old. I hope to live an active life for 25 more years.
I have decided to never change the oil in my tractor again. Why? Just bygod because I want to see what horrible calamity will befall me. For the last 30+ years I have listened to every armchair expert expound about what they know, what they do/did, what they read, what they were told, etc., etc, but not a one has the balls to find out if it is all true.
Very well, I will.
I've seen a few engines torn down in my lifetime. Never once have I seen a crank, rod, cam or pistons ate up by 'acids' in the oil and some of those engines were severely mistreated.
I had an uncle that died at the ripe age of 77 and never ever did he change oil in any vehicle or machine he owned. Never ever did the man have an engine failure.....ever.
So, I have fairly fresh engine and hopefully the time to find out what will happen. So here goes...this won't cost any of you, one thin dime and never ever will change your opinion or make your a$$ not stink. But, I'm going to find out. The crankcase has JD oil in it and a JD filter...we'll see how damned good they are!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
