Re: ??? CONTRADICTIONS ON CRANKSHAFT NUT TORQUE ???

Posted by Dick L on June 16, 2000 at 05:09:53 from (209.240.200.96):

In Reply to: ??? CONTRADICTIONS ON CRANKSHAFT NUT TORQUE ??? posted by Alberta Mike on June 15, 2000 at 08:33:56:

The 80 LBS would be fine, or go to 100 ft.lbs. if it makes you feel better. The crank shaft pully, on several of the older tractors, is pressed on over a key and held in place with a setscrew pressing against the key or going into a dimple or gruve in the crank. This adds up to 0 ft.lbs of torque on the end. Your just holding it in place and not holding back pressure. If it viberates enough that you think it might work lose, you need a different pully.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: ??? CONTRADICTIONS ON CRANKSHAFT NUT TORQUE ??? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]