Posted by Bob-O on March 18, 2009 at 19:03:17 from (70.195.36.132):
I know there are different classes of hitches. I have a Fordson super major. I came across an old FORD SINGLE PLOW AND BOUGHT IT. NOW, THE PROBLEM IS THE BARS-PINS ON THE PLOW ARE WAY TOO NARROW AND DON'T PROTRUDE FAR ENOUGH TO GET FAR ENOUGH THROUGH THE BALLS ON THE 3 POINT ON THE FSM. (SORRY ABOUT SHOUTING, JUST SAW CAPS WERE LOCKED. I think I can get smaller balls at tractor supply that will fit the older pins. These are not actually pins, rather where they ground down the end of the rods. Can someone please tell me about catagory sizes? Is cat1 the smallest and the cat 3 the largest? Does anyone have lenghts and diamiter of such? Are the littli tin straps what bhold the pin into the arm> If I break off one of those tins am I in DEEP bovine excrement?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
