Posted by Gerald J. on June 15, 2009 at 20:35:40 from (70.219.150.149):
In Reply to: 3rd reverse? posted by Ben Costello on June 15, 2009 at 18:55:53:
There is a 3rd reverse and a fourth reverse in the transmission. Third reverse was enabled in the 3010 and 4010, but not in the 3020 and 4020 because it was too fast for safety and the gears weren't strong enough to not break occasionally. Fourth reverse would be even worse about breaking stuff (in the transmission and near the tractor). The lock out is up in the dash shifter assembly. A bit of filing on a shifter that isn't worn has been known to add 3rd reverse to a 3020 or 4020.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
