Posted by souNdguy on June 24, 2009 at 15:42:01 from (71.55.200.44):
In Reply to: Re: yanmar 1500 posted by RoNofohio on June 24, 2009 at 14:21:21:
your ym240 is still a fully supported machine via yanmar. It's a domestic model as are most of the 3-digit models. my 1700 on the other hand is a grey market import, and for the most part.. unsupported.
Unless there was some huge change.. your machine is a common sump deal wanting utf fluid.. not gear oil. I used to have 240 manuals as they were 'close' to my 1700.. but I ended up giving them to a fellow that had a 195 ( manual covered the 240 and 195 ).. he needed them more than I did.
any yanmar dealer can still order tons of parts for your domestic machine.
15w40 c rated is a good generic diesel oil.. etc..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.