Posted by 440roadrunner on June 25, 2009 at 11:43:39 from (98.145.93.224):
In Reply to: alternator charging posted by Bob on June 25, 2009 at 09:38:19:
Bob said: (quoted from post at 09:38:19 06/25/09) It makes no difference to the actual charging mechanism, but the pulley MAY fall off!
Most Delcos ans many othere have no key in the pulley ), just depend upon the pulley turning in the direction that tightens the nut.
If you run that type of alternator the opposite rotation the load on the pulley will always be trying to work the nut loose. .
Absolute nonsense Every Delco I've ever seen on a car/ lite truck, and I've torn down a lot of them, had a right hand thread nut with no key, and last time I looked, cars and truck engines turned CLOCKWISE.
What may or may not make a difference is fan direction. Things like Corvairs had a reverse pitch alternator fan, as the generators and alternators on those ran CCW. However, if your tractor doesn't have much in the way of load, you'll probably get by fine.
We once converted an old Allis M crawler, reverse drove the alternator off the mag drive. Worked just fine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
