Tractor Talk Discussion Board |
Article Archive,Step-by-step 12V conv
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLight on November 02, 2000 at 10:06:30 from (216.208.109.82):
(Also posted on MFH discussion) I have 2 questions concerning this board's article archive, Step-by-Step 12 Volt Conversion topic. The diagram shows 1 and 2 poles on the S10 alternator. I have a delco-remy DR5MF I would like to use instead. It has 4 terminals GRND,BAT,F,R. So I assume F,R is the equivalent of 1 and 2 in the diagram. Is 1 = "F" and 2 = "R" or is that the opposite.? Also I am running straight off the battery, as a consequence I have to recharge the battery after every use. The alternator is belted but no connections are made yet. My 12 Volt battery works fine so do I still need a balast resistor as the coil seems to work fine on 12 Volt without one?. It could be a 12 Volt coil but can't say for sure. Thanks folks.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|