Mathias NY said: (quoted from post at 09:59:44 08/31/09) Try searching a little in the archives of the Ford forum. The link below is to a tread I started a while ago for the Hydraulics on my 3000. My issue still isn't resolved, but I have narrowed it down to the position/draft control adjustments.
To get at both hydraulic filters, drain the fluid, remove the seat, remove the transmission top cover, and remove the PTO shaft. I also removed the left floor board, but I can't remember if that was necisary. I also think there was an access cover on the left side that needed to be removed.
The attached picture is of my tractor after I changed both filters. The rear of the tractor is toward the right, the upper arrow is for the outlet filter, and the lower arrow is for the intake filter.
[/quote:df79a887e8][quote:df79a887e8]THANKS SO MUCH .. IV TAKEN THAT ROUND COVER OFF THE SIDE .. CAN I TAKE THE FILTERS OFF FROM HERE ... AND WILL HY TRAN WORK
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
