I'd start by looking carefully at the oil you are using. The newest automobile oils do not have the necessary ZDDP (zinc) additives needed to protect a flat tappet engine, whick I suspect the Briggs is. The oil companys have reduced the zinc to nearly Zero to meet the latest pollution standards.
If you check the certification label on the oil bottled with the Briggs label (and Kohler also) you will find it is certified for "SL" not the newest "SM" you find on the one labeled for car use. (I am going by memory here as to SL and SM, so may have not got it quite right, but I do know the small engine oil is manufactured to an earlier spec).
You can also get the necessary zinc by using an off road diesel rated oil, such as the Case IH #1, and maybe other brands too. I keep a barrel of the Case IH oil for use in my tractors and small engines.
If the B/S engine sat for many months with gasoline (or gasohol) in the tank, it may have turned very sticky. I have seen where it sticks the valves (and maybe even affects the piston rings & cylinder bore). Today's gas is made to be used within the next week or 2, and can become real evil when it sits for months.
I really doubt the Briggs "badmouthing" people. The Briggs may not be the very best engine in the market, but it doesn't suddenly go to he-l without some kind of reason. Your most recent oil changes seem to be the likely reasons. (And I have seen the Honda engines gummed up just like I described, the same with Kohler, and Techumseh. The seasonal use equipment like snowblowers, wood splitters, and rototillers seem to take the worst beating from the stale gas problem. The 2 cycle engines with gas/oil mix seem to be much better off because of the stabilizing additives in the oil.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's The "Stuckest" You've Ever Been? - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I was about 14 (part of the problem) when I got stuck. I was disking with a cab equipped IH 966. The window was dirty and I was driving into the evening sun. It was hard to see and it was my first pass down the field. I got the tractor so stuck that the underside of the tractor was resting on the ground. My uncle wanted
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
