Tractor Talk Discussion Board |
Hydraulic Pump Blowing Oil Seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve in Maryland on January 26, 2001 at 22:50:16 from (207.172.233.61):
A few weeks I rebuilt the hydraulic pump on an IH 424 Utility. No problem - or so I thought. Not too long afterward I noticed that the crankcase oil level was very high and realized that hydraulic fluid got in there somehow. I took the pump off, and saw that the oil seal moved out of its seat and got torn up. I got another seal and was extra careful when I installed it. Once again, I have hydraulic fluid in the crankcase. I haven't removed the pump yet, but I expect the same thing happened. The only difference I noticed is that the new oil seals (provided by the Case-IH dealer) weren't as thick as the original. But that shouldn't be an issue for an oil seal. Any ideas on what I'm doing wrong? Appreciate any help! - Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|