Tractor Talk Discussion Board |
Re: Hydraulic Pump Blowing Oil Seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike M (RI) on January 27, 2001 at 16:52:17 from (216.41.24.58):
In Reply to: Hydraulic Pump Blowing Oil Seal posted by Steve in Maryland on January 26, 2001 at 22:50:16:
Steve, I had to replace the front mounted pump on my Allis D14 loader/backhoe for the same reason. It started to push the shaft seal completely out of the casing...after replacing seals 3-4 times...I was told that pump was probably worn to the point that excess slippage around the gears was building way too much pressure behind the seal. A $400 pump was the painful cure to my problem...not the $3.00 seals...like I hoped.
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|