Posted by jcsinga on December 22, 2009 at 17:45:38 from (71.31.232.198):
I like to think of myself as a pretty well rounded mechanic, only thing I"ve never done to an automobile is rebuild an automatic transmission, well the opportunity presented itself a couple months ago.
2005 Ford Focus, (sister in laws car) we purchased the most complete rebuild kit Rock Auto offered, discs, plates, gaskets and seals. We have a Ford service manual for the car and went to work.
We had to buy an aluminum end plate from Ford as this is what was actually wrong with it, it had beaten out the flat roller bearing between the drum and plate and let the endplay get outta whack and ruin the plate.
Anyway we get it back in and it worked perfectly for a few hundred miles then it lost OD, well the kit didnt come with the OD band so we get one from Ford and install it, we didnt need it according to my measurements there was only .001 difference but it was inexpensive enough so we put it in, again it worked great for a few hundred miles.
Now we have lost 3rd and OD, never any CEL"s I tried my code scanner on it today and it had nothing. It will make the shift from 2nd to what should be 3rd but it just freewheels so I assume the solenoids are working.
My fears of the magic of auto trans. are coming home to roost. Can anyone offer an idea, word of encouragement, etc.?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
