|
Tractor Talk Discussion Board |
need to make tapered hole..how is it done
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Labrie on March 03, 2001 at 12:38:24 from (32.100.146.86):
I'm fashioning my own steering pin boss on my
1955 Massey Harris Pacer and since I'm reuseing
the original pin I need to taper a hole. The
hole needs to taper from 1" down to 13/16" over a 1 and 1/2" distance. The 1 1/2" thickness will
be made from layers of 1/8" plate steel welded
together. Is a tapered hole made with some type
of cone shaped stone bonded to a shaft?
Since I am building the boss from 1/8" I could
conceivably drill 13/16" in the first few layers,
then 7/8 " hole in the next few layers, then
15/16" holes int he next few and then weld the
sections together. Then maybe use a tapered stone
perhaps...if that is the method to get a tapered
hole.
Any ideas would be appreciated.
Thanks, Bob LaBrie
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
