Posted by Banditfarmer on March 06, 2010 at 19:53:55 from (174.103.146.69):
I have been doing a lot of reading on motor oils, and seen a lot of questions on this web site about what oil to put in an engine. I know that the oils being sold now are for engines that were built after 1995 and all of the oil standards have changed. The oil weights have changed to meet the EPAs standards for the new engines in cars, trucks and all other equipment. If you dont believe it look it up at API OIL STANDARDS and you can read it for yourself. Many of you guys know that a 30-W oil now is thin to what it use to be, and dose not hold the same oil pressure as it use to because it's made for the new engines not an old one. I am interested to ask you all out there what you think of these new oils in the old engines gas or diesel? And what you are running in your older engines that holds up the best. Bandit
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
