Tractor Talk Discussion Board |
Re: Re: Wrong Oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jakee on April 27, 2001 at 21:53:04 from (152.163.213.78):
In Reply to: Re: Wrong Oil posted by Ray,IN on April 26, 2001 at 20:43:53:
the valve stems on a 8-N ford face down,about 4 inches below the top of the block deck.they were never nowen to leak oil by the valve guides because the oil would have to floww up hill to get to the combustion chamber.most lickley the motor is just tired,run a leak down test on it and if it,s over 12 percent in needs the motor re-done.the reason they tell you to use non-detergent oil in it and it does not mater who made the motor,is that most of tractor motors up to the late 50,s didnot have a full flow oil filter,this meand only part of the oil was being filtered,so wen you start using detergent oil it starts washing every thing around in the motor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|