Posted by jdemaris on April 04, 2010 at 15:26:24 from (67.142.130.37):
In Reply to: Re: That is REDICULOUS posted by JohnDeere720GA on April 04, 2010 at 14:38:29:
I can read pretty well and your warning certainly was not just about "too much heat."
You stated, "Even if you get it apart with lube and heat the damage is done and it is a safety hazard as it looks fine but it is not . . . "
That is utter nonsense. Does it happen sometimes when hardware is overstressed, overheated, etc. ? Sure. Some people can screw anything up, and even someone who knows what he/she is doing will find fasteners that cannot be removed without damange. Certainly not all that are heated as you claim. If you mean what your words convey in everyday English, you are incorrect.
Your later comment, i.e. " if you feel the fastener yield it is too late to save it. "
That is even MORE nonsense. When a normal nut comes loose, it's yielding, rusty or lubed. It's a matter of how much torque it takes to yield. A bolt is a spring and had a yield point. If a nut seems to be rusted/stuck, and the normal amount of torque is not turning it, and adding some heat THEN allows it to turn, there is no change in metalurgy, no over-stress, and no problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
