However, most people are not aware of the less common six-lug, semi-floating version of the 14-bolt axle. GM called it the "9.5" 14-bolt (after its ring-gear diameter) and offered it exclusively in light-duty 3/4-ton pickups built between 1986 and "93. While not as strong as its eight-lug cousin, the semi-floating 14-bolt rearend does sport some noteworthy attributes. For instance, the all-important width measurement from wheel mounting surface to wheel mounting surface is 67 inches-perfect for most 1/2-ton pickups. Generally, you wouldn"t even need to change mounting brackets to bolt this housing right into the rear of a 1/2-ton GM pickup because the leaf spring architecture is identical. We like the fact that the ring gear measures out at a healthy 9 1/2-inch diameter, and the 33-spline axleshafts have a 1.370-inch diameter-a sure improvement in strength over the typical 1/2-ton shafts. This less grown-up version of the 14-bolt may not have the extra pinion support bearing of its eight-lug cousin, but it"s rated to handle 5,000 lb-ft of torque, so it"s no lightweight either. Moreover, aftermarket suppliers such as Randy"s Ring and Pinion offer all the upgrade goodies you need to make this rear end survive with up to 37-inch-tall rubber. As a result, owners of virtually any GM 1/2-ton pickup offered with six-lug wheels can benefit greatly from a semi-float 14-bolt axle upgrade.
Here is the kicker: Thanks to the semi-floating design, a factory-style wheel will bolt right up. This means you do not have to spend your hard-earned cash on eight-lug wheels to get vast improvements in overall axle strength. We think these axles are the cat"s meow for trucks equipped from the factory with 10- or 12-bolt rear axles.
JD IIRC 9.5" were 6 lug semi floaters GVW 7700lb, GAWR RR around 5000 or 5200 lbs. 10.5" were 8 bolt full floaters. I think those were commonly at 8600GVW and 6000lb GAWR RR.
Then Dana 60/70 were in the 3500 series. These had 6000lb GWARR. 8600 GVW
Later I think the 3500 went to a 9200GVW still with a 6000 axle rating. I use to have all this info, but pitched it about 10 years ago, thinking I would never look at it.
Not sure my numbers are correct, maybe someone else can verify them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.