Our small generator died during Hurricane Ike in 2008, so I had to stand in line at Home Depot and bought a 8.5 kw Generac. Of course, the power came back on after a day instead of being out for a week like they had been saying. Afterwards I had the electrician come out and install a transfer switch and an outlet so we set the generator out in the carport and plug it into the house panel directly. Sounded good on paper but after the electrician installed everything and we plugged in the generator, the breaker on the generator would immediately trip. electrician said it was faulty, so we took it back for warranty service. Service center said it was fine, took it home and still wouldn't work. Made several calls to Generac, who swore that it should be working for our application. To make a long story short, it turned out that OSHA now requires all "commercial" generators to have built in GFI on 220 side(which is what we were connecting into the service panel) and with the GFI, it won't let it feed into the house box. So after two trips to get generator serviced and three visits from the electrician, the final solution was to bypass the GFI breaker on the generator and now it works as intended. Generac was of no help at all, the representatives we talked to had no idea about the GFI situation. I'm not an electrician, so maybe I don't have the story exactly straight, but I know that it was a two month ordeal that ended up costing way more than I expected - those transfer switches are not cheap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
