Posted by LOU from Wi on March 29, 2011 at 16:26:35 from (174.124.92.38):
In Reply to: How would you do it ? posted by Billy NY on March 29, 2011 at 16:13:47:
Can only speak for myself, I would take and loosen the collar behind the bearing, move it back towards the flighting,take some fine sand paper,or emery cloth, clean the shaft in front of the bearing.Put a bearing separator behind the bearing and lube the shaft with oil or light grease,then try to pull the bearing loose with the separator. If all else fails could get a new bearing,cut thru the outer cage,remove the bearings and retainer sleeve,then carefully cut the inner bearing sleeve,I usually use a cut off tool or a grinder with a cut off wheel.When you get close to the shaft,I take a chisel,hammer and finish cracking thru the sleeve,as to not damage the shaft with a score mark from the cutter wheel. Also, take a few measurements before hand on where the bearing is from the shaft edge. Just how I would do it, not saying you are supposed to do it my way.Hope this helps. Regards, Victor
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
