Farmall & IHC Tractors Discussion Board |
Ignition switch for 300 farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul on November 06, 2001 at 17:42:04 from (66.41.3.57):
I asked the other day for a wire diagram but got no responce so I am going into more detail about the information I need. I just converted a 300 farmall from 6 volt to 12 volt and have it all hooked up and it starts and runs well, the problem I have is I need to know what wires are hooked to the 4 post on the ignition switch. I took a meter and found out what post are keyed and hooked it up. the first time it started and ran but when I turned the key off the starter kicked in, I then changed the post and then it would turn over but wouldnt start till the starter quit turning. the third time everthing worked but when I turned the key off it keeps running if the throtle is open a little bit but if in at an idle it will kill about 5 seconds after I turn the key off. I can qive more information as to how i wired it if needed thanks if you can help me Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|