Farmall & IHC Tractors Discussion Board |
Replacement notched type throttle (M, H, etc.)?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by zim on December 09, 2001 at 19:45:44 from (65.28.240.2):
My M is having throttle problems. It won't hold its throttle position. Instead, it pulls back to idle when I release it. It is the notched type with the replaceable piece that fits the notches. My next step is going to be installing new spring under the throttle lever. It seems to be very weak. I snagged a better "replaceable piece" from Dad's H (temporarily of course), but it didn't help. We've adjusted the linkage, etc. but nothing has helped yet. We've never had great luck with the friction throttle version. It seems they have to be so tight to hold that they are rough to pull once they wear a little. If the problem turns out to be that the notches are too worn out, does any company carry new throttle assemblies?
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|