|
Farmall & IHC Tractors Discussion Board |
Got a problem on my 49M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jack on December 28, 2001 at 11:03:14 from (208.47.8.72):
I just got my M and it did not run when I got it.This M was an all fuel and I put a gas manifold on it.It would crank with the choke closed and if I opened the choke flap much it would quit.I pulled the carb off and cleaned the needle and seat and took out the nozzel that has the six little holes in it and cleaned all that I could find.I put the carburator back on and it runs a little better but the choke still has to be almost closed to run.I took the fuel line off and I have a good flow to the carb.There is a little brass nozzel that sticks up when the carb is apart and that was broken off.I do not know what this little brass strawlike piece did but could this be my problem?I am sure it isn't much but I need a fresh perspective.As soon as I open the choke it quits.Thanks,Jack(TN).
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
