Re: IH 140 - Dist to Alternator conversion: Brack

Posted by Hugh MacKay on February 24, 2007 at 17:55:22 from (209.226.106.176):

In Reply to: IH 140 - Dist to Alternator conversion: Bracket? posted by Nawlens Gator on February 24, 2007 at 16:56:15:

Nawlens: I fabricated one of these, it put the alternator very close to same position as the generator had been. I did not have to disturb the shroud. Before describing this for you I'd like to go to my shop, look it over close, take a few measurments, etc. It's been 3 years, thus some details have sliped my recall.

I can tell you the first step I take in installing an alternator on one of these offset Farmalls, is find a dual pulley from a 1980s V8 GM car or pickup engine. This allows you to set alternator back just a bit giving more room by using the outer pulley, for the belt.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]